WARNING When moving the cabinet with the casters installed, the cabinet must be raised no higher than two inches from the floor to maintain stability.
![]() HP shall not be liable for technical or editorial errors or omissions contained herein. There are now two versions of racks for seismic systems: the original seismic rack and seismic rack R2. Some of these options are necessary for full NEBS compliance. Part Number (Seismic Rack Option Name Product Number Part Number (Seismic Rack). The customer assumes all risk in using the seismic rack on a raised floor. For your sites floor system, consult with your HP site preparation specialist or an appropriate floor system engineer. Installing and using the system in strict accordance with HP instructions minimizes the chances that the system will cause radio or television interference. However, HP does not guarantee that the system will not interfere with radio and television reception. Ensure that all panels and cover plates are in place and secure before system operation. Electrostatic discharge Preventing electrostatic discharge To prevent damaging the system, be aware of the precautions you must follow to set up the system or handle parts. The HP DC Power Supply, cable management system, and seismic brace are intended for use in the HP BladeSystem c7000 Enclosure and HP Carrier-Grade rack. TE10, TE12S, TE52 or equivalent) 18 mm (34 inch) high-speed drill bit (Hilti part number TC-F- 1 834 or equivalent) For seismic rack. ![]() M12 anchor hole depth must be 102 mm (4 in.) Move the side handle of the hammer drill to a convenient position and tighten in a clockwise direction. Removing the rack door To provide access to all sides of the rack while you are installing the various components, first remove the rack doors. Hp Bladesystem C7000 Enclosure Free Of TheMove the top of the door away from the rack so that the spring-loaded pin is free of the hinge assembly. To remove a kickplate: For the seismic rack: Turn the quarter-turn fasteners securing the kickplate. Hp Bladesystem C7000 Enclosure Driver To UnscrewFor the seismic rack R2: Use a T30 torx screwdriver to unscrew the six screws securing the kickplate. For the seismic rack R2: Using a 17-mm socket wrench, unscrew the four bolts securing the rack to the pallet. The casters are designed for short-distance moves over a smooth, hard surface or short-pile carpeting. Using the caster kit items and the rack rail, add four casters to the bottom of the rack frame: For the seismic rack: Retrieve the appropriate caster unit (left or right) from the caster kit.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |